Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

AIRBAG SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3. The DTCs are communicated through SRS warning light blinking patterns.

HINT:
When one or more of the warning lights blinks continuously, the cause may be a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU.


WIRING DIAGRAM


C240459E05


INSPECTION PROCEDURE

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

1.CHECK WIRE HARNESS (DLC3 - CENTER AIRBAG SENSOR AND BODY GROUND)
H100393E03
  1. Disconnect the A24 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    D3-13 (TC) - A24-15 (TC)
    Below 1 Ω
    D3-4 (CG) - Body ground
    Below 1 Ω
    A24-15 (TC) - Body ground
    1 MΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY