ENGINE IMMOBILISER SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
| |||||
| 3.CRANK ENGINE FOR MORE THAN 10 SECONDS |
Check that the engine cranks for more than 10 seconds.
| Result | Proceed to |
| OK | A |
| NG (for 1KD-FTV) | B |
| NG (for 2TR-FE) | C |
| NG (for 1GR-FE) | D |
| NG (for 2TR-FBE) | E |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| |||||
| 4.CHECK FOR DTC* |
Check for DTCs and note any codes that are output (Click here).
Clear the DTC.
Based on the DTCs output above, try to force output of the same ECD system*1 or SFI system*2, engine immobiliser system and blocking system*3 DTCs by reproducing the monitoring conditions indicated by the DTCs.
| Result | Proceed to |
| DTC is not output. | A |
| ECD system DTC is output (for 1KD-FTV). | B |
| SFI system DTC is output (for 2TR-FE). | C |
| SFI system DTC is output (for 1GR-FE). | D |
| SFI system DTC is output (for 2TR-FBE). | E |
| Blocking system DTC is output. | F |
| Engine immobiliser system DTC is output. | G |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
|
| ||||
| |||||
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Data List/Active Test (Click here).
Terminals of ECU (Click here).
Inspection (Click here).
| |||||
| 7.ADJUST, REPAIR OR REPLACE |
| |||||
| 8.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|