Home › BODY › SEAT › FRONT SEAT ASSEMBLY (for Manual Seat)

FRONT SEAT ASSEMBLY (for Manual Seat) > INSTALLATION

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL FRONT SEAT ASSEMBLY
  1. Place the front seat assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Connect the connector and attach the wire harness clamp under the seat.

  1. Temporarily install the front seat assembly with the 4 bolts.

  1. Lift up the seat track handle sub-assembly LH and move the seat to the rearmost position.



    B207785E01
  1. Tighten the bolts in the order shown in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Lift up the seat track handle sub-assembly LH and move the seat to the foremost position.



    B207784E01
  1. Tighten the bolts in the order shown in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



2. INSTALL FRONT SEAT HEADREST ASSEMBLY
  1. Install the front seat headrest assembly.



3. INSTALL SEAT TRACK COVER LH


    B108448E03
  1. Attach the 2 claws in the order shown in the illustration to install the seat track cover LH.

    NOTICE:
    Be careful not to damage the claws.



4. INSTALL INNER SEAT TRACK BRACKET COVER LH


    B108449E03
  1. Attach the 2 claws in the order shown in the illustration to install the inner seat track bracket cover LH.

    NOTICE:
    Be careful not to damage the claws.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for Front Passenger Side, w/ Front Seat Side Airbag)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



6. CHECK SRS WARNING LIGHT (for Front Passenger Side, w/ Front Seat Side Airbag)
(Click here)