Home › ENGINE ยท 2TR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM (w/ Secondary Air Injection System)

SFI SYSTEM (w/ Secondary Air Injection System) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


Troubleshoot in accordance with the procedures shown below.

HINT:
*: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.CONNECT INTELLIGENT TESTER TO DLC3*

        HINT:
        If the display indicates a communication fault with the tester, inspect the DLC3.


      NEXT


      4.CHECK DTC AND FREEZE FRAME DATA*

        HINT:
        Record or print DTCs and freeze frame data if needed.


      NEXT


      5.CLEAR DTC AND FREEZE FRAME DATA*

        NEXT


        6.CONDUCT VISUAL INSPECTION

          NEXT


          7.SET CHECK MODE DIAGNOSIS*

            NEXT


            8.CONFIRM PROBLEM SYMPTOMS

              HINT:
              If the engine does not start, first perform the "check DTC" procedures and "conduct basic inspection" procedures below.

              Result:
              Result
              Proceed to
              Malfunction does not occur
              A
              Malfunction occurs
              B



            B.
            Go to step 10
            A


            9.SIMULATE SYMPTOMS

              NEXT


              10.CHECK DTC*

                Result:
                Result
                Proceed to
                DTC is output
                A
                DTC is not output
                B



              B.
              Go to step 12
              A


              11.REFER TO DTC CHART

                NEXT

                Go to step 14


                12.CONDUCT BASIC INSPECTION

                  Result:
                  Result
                  Proceed to
                  Malfunctioning parts not confirmed
                  A
                  Malfunctioning parts confirmed
                  B



                B.
                Go to step 17
                A


                13.REFER TO PROBLEM SYMPTOMS TABLE

                  Result:
                  Result
                  Proceed to
                  Malfunctioning circuit confirmed
                  A
                  Malfunctioning parts confirmed
                  B



                B.
                Go to step 17
                A


                14.CHECK ECM POWER SOURCE CIRCUIT
                1. Check the ECM power source circuit (Click here)


                NEXT


                15.CONDUCT CIRCUIT INSPECTION

                  Result:
                  Result
                  Proceed to
                  Malfunction not confirmed
                  A
                  Malfunction confirmed
                  B



                B.
                Go to step 18
                A


                16.CHECK FOR INTERMITTENT PROBLEMS

                  NEXT

                  Go to step 18


                  17.CONDUCT PARTS INSPECTION

                    NEXT


                    18.IDENTIFY PROBLEM

                      NEXT


                      19.ADJUST AND/OR REPAIR

                        NEXT


                        20.CONDUCT CONFIRMATION TEST

                          NEXT

                          END