Home › ENGINE ยท 2TR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM (w/ Secondary Air Injection System)

SFI SYSTEM (w/ Secondary Air Injection System) > FAIL-SAFE CHART

for Preparation Click here


If any of the following codes are recorded, the ECM enters fail-safe mode.

DTC No.
Item
Fail-safe Operation
Fail-safe Deactivation Condition
P0011
Variable Valve Timing (VVT) System
  1. Idle up (control of combustion worsening)
  2. Stopping fuel cut control
"Pass" condition detected
P0031
P0032
Air-Fuel Ratio Sensor
A/F heater is turned off
Ignition switch turned off
P0037
P0038
Heated Oxygen Sensor
Heated Oxygen Sensor (HO2S) heater is turned off
Ignition switch turned off
P0102
P0103
Mass Air Flow Meter
If engine is running at over 3000 rpm, ECM performs fuel cut.
"Pass" condition detected
P0112
P0113
Intake Air Temperature Sensor
ECM fixes intake air temperature at 20°C (68°F).
"Pass" condition detected
P0115
P0117
P0118
Engine Coolant Temperature
Sensor
ECM fixes engine coolant temperature at 80°C (176°F).
"Pass" condition detected
P0120
P0121
P0122
P0123
P0220
P0222
P0223
P0604
P0606
P060A
P060D
P060E
P0657
P2102
P2103
P2111
P2112
P2118
P2119
P2135
Electronic Throttle Control System
If electronic throttle control system is malfunctioning, ECM cuts off current to throttle actuator. Throttle control valve returns to predetermined throttle position (approximately 6.5°) by force of return spring.
Then, required engine power is calculated by using ignition timing and accelerator pedal position. Engine is controlled by intermittent fuel cut. If accelerator pedal is depressed firmly and slowly, vehicle can be driven at minimum speed. If accelerator pedal is depressed quickly, vehicle may speed up and slow down erratically.
"Pass" condition detected and then ignition switch turned off
P0327
P0328
Knock Sensor
ECM sets ignition timing delay to maximum.
Ignition switch turned off
P0351
P0352
P0353
P0354
Igniter
If engine is running at over 500 rpm, ECM performs fuel cut in malfunctioning cylinders.
Engine performs fuel cut in all cylinders if: 1) engine is running at over 1500 rpm, and 2) engine load rate is 20 to 89% or more.
"Pass" condition detected
P0504
Stop Light Switch
Accelerator pedal angle is fixed
"Pass" condition detected
P2120
P2121
P2122
P2123
P2125
P2127
P2128
P2138
Accelerator Pedal Position Sensor
Accelerator pedal position sensor has 2 sensor circuits: Main and Sub.
If either circuit malfunctions, the ECM controls the engine using the other circuit.
If both circuits malfunction, the ECM regards the accelerator pedal as being released. As a result, the throttle valve closes and the engine idles.
"Pass" condition detected and then ignition switch turned off
P2237
P2238
P2239
P2252
P2253
Air Fuel Ratio Sensor
  1. Air-fuel ratio feedback control is stopped.
  2. Current to the air fuel ratio sensor heater is cut.
"Pass" condition detected and then ignition switch turned off