Home › DRIVE LINE › PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY (for TSAM Made)

FRONT PROPELLER SHAFT ASSEMBLY (for TSAM Made) > INSTALLATION

for Preparation Click here



1. INSTALL FRONT PROPELLER SHAFT ASSEMBLY
  1. Completely remove any oil or the like and clean the contact surfaces of the propeller shaft flange and transfer flange.

  1. Align the matchmarks on the propeller shaft flange and transfer flange.

  1. Install the propeller shaft with the 4 nuts and 4 washers.

    Torque:
    88 N*m{ 899 kgf*cm , 65 ft.*lbf }

  1. Completely remove any oil or the like and clean the contact surfaces of the propeller shaft flange and differential flange.

  1. Align the matchmarks on the propeller shaft flange and differential flange.

  1. Connect the propeller shaft with the 4 bolts, 4 nuts and 4 washers.

    Torque:
    88 N*m{ 899 kgf*cm , 65 ft.*lbf }