Home › DRIVE LINE › PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY (for TMMIN Made)

FRONT PROPELLER SHAFT ASSEMBLY (for TMMIN Made) > DISASSEMBLY

for Preparation Click here



1. REMOVE UNIVERSAL JOINT SPIDER ASSEMBLY


F015023E15

HINT:
Use the same procedure for both universal joint spiders.

  1. Place matchmarks on the flange yoke and propeller shaft.
    Text in Illustration 
    *1
    Matchmark



    C061264E01
  1. Using a brass bar and hammer, slightly tap in the spider bearing outer races.

  1. Using 2 screwdrivers, remove the 4 snap rings from the grooves.



    F015025E01
  1. Clamp the propeller shaft in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Using SST, push the sleeve yoke side spider bearing until: 1) the spider almost touches the sleeve yoke or propeller shaft, and 2) the spider bearing on the opposite side is partially pushed out.

    SST
    09332-25010  

    HINT:
    Before installing SST, sufficiently raise the part labeled A. If part A is too low, SST may be difficult to install.



    C237736E01
  1. Clamp the pushed out spider bearing outer race in a vise between aluminum plates and tap the propeller shaft to remove the spider bearing.
    Text in Illustration 
    *1
    Plastic-faced Hammer
    *a
    Hammering Point

    NOTICE:
    1. Do not tap the shaft tube.
    2. Do not overtighten the vise.

    HINT:
    Use the same procedure to remove the spider bearing from the opposite side of the spider.

  1. Separate the flange yoke and spider from the propeller shaft.



    F015030E01
  1. Reinstall the 2 removed spider bearings to the spider and clamp the spider bearings in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Using SST, push the flange yoke side spider bearing until: 1) the spider almost touches the flange yoke, and 2) the spider bearing on the opposite side is partially pushed out.

    SST
    09332-25010  

    HINT:
    Before installing SST, sufficiently raise the part labeled A. If part A is too low, SST may be difficult to install.



    C237737E01
  1. Clamp the pushed out spider bearing outer race in a vise between aluminum plates and tap the flange yoke to remove the spider bearing.
    Text in Illustration 
    *1
    Plastic-faced Hammer
    *a
    Hammering Point

    NOTICE:
    Do not overtighten the vise.

    HINT:
    Use the same procedure to remove the spider bearing from the opposite side of the spider.

  1. Separate the spider from the flange yoke.