FRONT PROPELLER SHAFT ASSEMBLY (for TSAM Made) > REASSEMBLY |
| 1. INSTALL UNIVERSAL JOINT SPIDER ASSEMBLY |
![]() |
Apply MP grease to a new spider and 2 new spider bearings.
Fit the spider into the flange yoke.
![]() |
Using SST, install the 2 spider bearings to the spider.
![]() |
Using SST, adjust the spider bearings so that: 1) the flange yoke does not overlap the snap ring grooves of the spider bearings; 2) the grooves are as wide as possible; and 3) the groove width on both sides is the same.
Install 2 new snap rings to the installed spider bearings. The snap rings must have equal thickness and allow 0 to 0.05 mm (0 to 0.00196 in.) of axial play.
| Part No. | Thickness | Color |
| 90080-52044 | 1.384 mm (0.0545 in.) | Green |
| 90080-52174 | 1.39 mm (0.0547 in.) | Green |
| 90080-52043 | 1.435 mm (0.0565 in.) | Red |
| 90080-52175 | 1.44 mm (0.0567 in.) | Orange |
| 90080-52041 | 1.486 mm (0.0585 in.) | Black |
| 90080-52176 | 1.49 mm (0.0587 in.) | Black |
| 90080-52042 | 1.511 mm (0.0595 in.) | Copper |
| 90080-52040 | 1.537 mm (0.0605 in.) | Silver |
| 90080-52177 | 1.54 mm (0.0606 in.) | White |
| 90080-52039 | 1.588 mm (0.0625 in.) | Yellow |
| 90080-52178 | 1.59 mm (0.0626 in.) | Yellow |
| 90080-52038 | 1.638 mm (0.0645 in.) | Blue |
| 90080-52179 | 1.64 mm (0.0646 in.) | Red |
| 90080-52180 | 1.69 mm (0.0665 in.) | Blue |
![]() |
Using a plastic-faced hammer, tap the flange yoke until there is no clearance between the spider bearings and snap rings.
| *a | Hammering Point |
Align the matchmarks on the flange yoke and propeller shaft.
Install new spider bearings on the sleeve yoke side.
| 2. INSPECT UNIVERSAL JOINT SPIDER ASSEMBLY |
Clamp the propeller shaft in a vise between aluminum plates.
Check the spider bearings for wear or damage.
![]() |
Check the axial play of each spider bearing by turning the yoke while holding the shaft tightly.
| 3. INSTALL SLIDING SHAFT BOOT |
Temporarily install the boot to the propeller shaft with 2 new clamps.
Mount the propeller shaft in a soft vise.
Coat the splines of the propeller shaft with MP grease.
Align the matchmarks on the propeller shaft and sleeve yoke.
Install the sleeve yoke to the propeller shaft and connect the boot.
![]() |
Secure one of the boot clamps to the boot.
Place SST onto the boot clamp.
Tighten SST so that the boot clamp is pinched as shown in the illustration.
![]() |
Using SST, adjust the clearance of the boot clamp.
Secure the remaining boot clamp to the boot.
| 4. INSPECT PROPELLER SHAFT GREASE FITTING DIRECTION |

| *1 | No. 1 Grease Fitting | *2 | No. 2 Grease Fitting |
| *a | Spider grease fitting assembly direction for front propeller shaft assembly | *b | Rear Side |