Home › DRIVE LINE › PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY (for DANA Made)

PROPELLER SHAFT ASSEMBLY (for DANA Made) > INSTALLATION

for Preparation Click here



1. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for Pre-Runner)


C098710E01
  1. Remove SST from the extension housing.

  1. Install the propeller shaft to the extension housing.

  1. Temporarily install the center support bearing with the 2 plates and 2 bolts. Tighten the bolts as much as possible by hand.



    C119752E01
  1. Align the matchmarks on the propeller shaft flange and differential flange.

  1. Connect the propeller shaft with the 4 washers, 4 bolts and 4 nuts.

    Torque:
    88 N*m{ 897 kgf*cm , 65 ft.*lbf }



    C118622E02
  1. Unload the vehicle. Adjust the bearing so that the center line of the center bearing and center bearing housing (see illustration) are within 0 +/-1 mm (0 +/-0.0394 in.) of each other. Measure the difference along the vehicle front/rear axis.

  1. Tighten the 2 bolts of the center support bearing.

    Torque:
    36 N*m{ 367 kgf*cm , 27 ft.*lbf }



2. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for 4WD)


    C118613E01
  1. Align the matchmarks on the propeller shaft flange and transfer flange.

  1. Install the propeller shaft and 4 washers with the 4 nuts.

    Torque:
    88 N*m{ 897 kgf*cm , 65 ft.*lbf }

  1. Align the matchmarks on the propeller shaft flange and differential flange.



    C119752E01
  1. Connect the propeller shaft with the 4 washers, 4 bolts and 4 nuts.

    Torque:
    88 N*m{ 897 kgf*cm , 65 ft.*lbf }