Home › DRIVE LINE › PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY (for DANA Made)

PROPELLER SHAFT ASSEMBLY (for DANA Made) > REMOVAL

for Preparation Click here



1. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for Pre-Runner)


C119752E04
  1. Place matchmarks on the propeller shaft flange and differential flange.

  1. Remove the 4 nuts, 4 bolts and 4 washers, and disconnect the propeller shaft.



    C118612
  1. Remove the 2 bolts and 2 plates from the frame crossmember.

  1. Remove the propeller shaft.



    C098710E05
  1. Install SST to the extension housing to prevent oil leakage.

    SST
    09325-40010  



2. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for 4WD)


C118613E01
  1. Place matchmarks on the propeller shaft flange and transfer flange.

  1. Remove the 4 nuts and 4 washers, and disconnect the propeller shaft.



    C119752E02
  1. Place matchmarks on the propeller shaft flange and differential flange.

  1. Remove the 4 nuts, 4 bolts and 4 washers.

  1. Remove the propeller shaft.