Home › DRIVE LINE › PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY (for DANA Made)

PROPELLER SHAFT ASSEMBLY (for DANA Made) > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR SLIDING SHAFT BOOT (for 4WD)
  1. Place matchmarks on the propeller shaft and sleeve yoke.

  1. Using a side cutter or pliers, remove the small and large boot clamps.

  1. Disconnect the boot from the sleeve yoke.

  1. Remove the sleeve yoke, and then remove the boot from the propeller shaft.



2. REMOVE UNIVERSAL JOINT SPIDER ASSEMBLY

HINT:
Remove the other universal joint spider(s) using the same procedures.



    F052432E02
  1. Place matchmarks on each pair of parts connected by a universal joint spider.



    F052433E01
  1. Using a brass bar and hammer, slightly tap in the spider bearing outer races.

  1. Using needle nose pliers, remove the 4 snap rings from the grooves.



    F015025E01
  1. Clamp the shaft in a vise between aluminum plates.

  1. Using SST, push the spider bearing on one side until: 1) the spider almost touches the yoke or shaft, and 2) the spider bearing on the opposite side is partially pushed out.

    SST
    09332-25010  

    HINT:
    Before installing SST, sufficiently raise the part labeled A. If part A is too low, SST may be difficult to install.



    F044192E07
  1. Clamp the pushed out spider bearing outer race between aluminum plates in a vise and tap the shaft or yoke to remove the spider bearing.

    NOTICE:
    Do not tap the shaft tube.

    HINT:
    Remove the spider bearing on the opposite side of the spider using the same procedure.

  1. Remove the yoke and spider from the shaft.



    F015030E01
  1. Reinstall the 2 removed spider bearings to the spider and clamp the spider bearings between aluminum plates in a vise.

  1. Using SST, push the spider bearing on one side until: 1) the spider almost touches the yoke, and 2) the spider bearing on the opposite side is partially pushed out.

    SST
    09332-25010  

    HINT:
    Before installing SST, sufficiently raise the part labeled A. If part A is too low, SST may be difficult to install.



    F044193E01
  1. Clamp the pushed out spider bearing outer race between aluminum plates in a vise and tap the yoke to remove the spider bearing.

    HINT:
    Remove the spider bearing from the opposite side of the spider using the same procedure.

  1. Remove the spider from the yoke.



3. REMOVE CENTER NO. 1 SUPPORT BEARING ASSEMBLY


C118616
  1. Clamp the center yoke in a vise between aluminum plates.

  1. Using a hammer and chisel, loosen the staked part of the lock nut and remove the lock nut and washer.



    C118617E01
  1. Place matchmarks on the intermediate shaft and center yoke.

  1. Using a brass bar and hammer, tap out the center yoke.

  1. Remove the washer and center support bearing from the intermediate shaft.