FRONT DRIVE SHAFT ASSEMBLY > REASSEMBLY |
| 1. INSTALL FRONT AXLE HUB DUST SEAL |
![]() |
Using a screwdriver and hammer, tap in a new dust seal.
| 2. INSTALL FRONT DRIVE SHAFT DUST COVER |
![]() |
Using SST and a press, press in a new dust cover.
| 3. INSTALL HOLE SNAP RING |
Install a new snap ring.
| 4. INSTALL INBOARD JOINT BOOT |
![]() |
Temporarily install a new outboard joint boot (with 2 boot clamps) to the drive shaft.
Pack the outboard joint shaft and boot with grease from the boot kit.
| 5. INSTALL FRONT AXLE OUTBOARD JOINT BOOT CLAMP LH |
![]() |
Mount the drive shaft in a soft vise.
Secure the outboard joint large boot clamp onto the boot.
Place SST onto the clamp.
Tighten SST so that the boot clamp is pinched as shown in the illustration.
![]() |
Using SST, adjust the clearance of the clamp.
For the outboard joint small boot clamp, use the same procedures described above.
| 6. INSTALL INBOARD JOINT BOOT |
Install a new inboard joint boot to the outboard joint shaft.
| 7. INSTALL INBOARD JOINT |
![]() |
Align the matchmarks of the tripod and outboard joint.
Using a brass bar and hammer, tap the tripod onto the outboard joint.
Pack the inboard joint and boot with grease from the boot kit.
Using a snap ring expander, install a new snap ring.
Align the matchmarks of the inboard joint and outboard joint.
Install the inboard joint to the outboard joint.
| 8. INSTALL FRONT AXLE INBOARD JOINT BOOT CLAMP |
![]() |
Using pliers, compress the large clamp and attach the claws.
![]() |
Secure the boot clamp onto the boot.
Place SST onto the clamp.
Tighten SST so that the boot clamp is pinched as shown in the illustration.
![]() |
Using SST, adjust the clearance of the small boot clamp.
| 9. INSPECT FRONT DRIVE SHAFT ASSEMBLY LH |
![]() |
*1:
Check that there is no excessive play in the outboard joint.
*2:
Check that the inboard joint slides smoothly in the thrust direction.
*3:
Check that there is no excessive play in the radial direction of the inboard joint.
*4:
Check the boots for damage.