ANTI-LOCK BRAKE SYSTEM > OPERATION CHECK |
| CHECK ABS WARNING LIGHT |
![]() |
When the ignition switch is turned ON, check that the ABS warning light illuminates and then turns off in approximately 3 seconds.
| CHECK SENSOR SIGNAL BY TEST MODE (When not Using Intelligent Tester) |
![]() |
Procedures for test mode:
Turn the ignition switch OFF.
Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3.
Start the engine.
![]() |
Check that the ABS warning light blinks as shown in the illustration.
![]() |
4WD:
Check shift lever position.
Start the engine, and turn the center differential lock switch OFF.
Check that the center differential lock indicator light illuminates when the transfer shift lever is moved from the N or LL position to the HL or H position.
Check that the center differential lock indicator light turns off when the transfer shift lever is moved from the HL or H position to the N or LL position.
Check the deceleration sensor.
Create gravitational force (0.2 G or more) on the vehicle through deceleration. Use one of the following methods to decelerate the vehicle in the direction it is moving:
When the deceleration sensor is 0.2 G or more, check that the ABS warning light illuminates.
Check the speed sensor.
Drive the vehicle straight forward at the following speeds. Then check that the ABS warning light is as follows.
| Vehicle Speed | Check | ABS Warning Light |
| 3 to 5 km/h (2 to 3 mph) | Response of sensors | Blinking |
| 45 km/h (28 mph) or higher | Deviations of sensor signal | Turns off |
Stop the vehicle.
![]() |
Read the DTCs.
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
Read the number of blinks of the ABS warning light.

After the check, disconnect SST from terminals 13 (TC) and 4 (CG) of the DLC3.
| CHECK SENSOR SIGNAL BY TEST MODE (When Using Intelligent Tester) |
![]() |
Procedures for test mode:
Turn the ignition switch OFF.
Check that the shift lever is on P.
Connect the intelligent tester to the DLC3.
Start the engine.
Select the Test Mode using the intelligent tester.
![]() |
Check that the ABS warning light blinks.
Start the engine.
![]() |
4WD:
Check shift lever position.
Start the engine, and turn the center differential lock switch OFF.
Check that the center differential lock indicator light illuminates when the transfer shift lever is moved from the N or LL position to the HL or H position.
Check that the center differential lock indicator light turns off when the transfer shift lever is moved from the HL or H position to the N or LL position.
Check the deceleration sensor.
Create gravitational force (0.2 G or more) on the vehicle through deceleration. Use one of the following methods to decelerate the vehicle in the direction it is moving:
When the deceleration sensor is 0.2 G or more, check that the ABS warning light illuminates.
Check the speed sensor.
Drive the vehicle straight forward at the following speeds. Then check that the ABS warning light is as follows.
| Vehicle Speed | Check | ABS Warning Light |
| 3 to 5 km/h (2 to 3 mph) | Response of sensors | Blinking |
| 45 km/h (28 mph) or higher | Deviations of sensor signal | Turns off |
Stop the vehicle.
Read the DTC(s).
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Read the DTCs by following the prompts on the tester screen.