SPIRAL CABLE > INSTALLATION |
| 1. INSTALL SPIRAL CABLE SUB-ASSEMBLY |
Check that the front wheels are facing straight ahead.
Set the turn signal switch to the neutral position.
Install the spiral cable.
Connect the connectors to the spiral cable.
| 2. INSTALL STEERING COLUMN COVER UPPER |
| 3. INSTALL STEERING COLUMN COVER LOWER |
![]() |
Install the cover with the 3 screws.
| 4. POSITION SPIRAL CABLE |
![]() |
Slowly rotate the spiral cable counterclockwise by hand until it feels firm.
![]() |
Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
| 5. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks on the steering wheel and main shaft.
Install the steering set nut.
| 6. INSTALL STEERING PAD ASSEMBLY |
![]() |
Support the steering pad with one hand.
Connect the connector to the steering pad.
Connect the horn connector.
Confirm that the groove along the circumference of the "TORX" screw is attached to the screw case and place the steering pad onto the steering wheel.
Using a T30 "TORX" socket wrench, tighten the 2 screws.
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 8. INSPECT STEERING PAD ASSEMBLY |
With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.
Make sure that the horn sounds.
If the horn does not sound, inspect the horn system.
| 9. PERFORM INITIALIZATION |
Perform initialization (Click here).
| 10. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).
| 11. INSPECT STEERING WHEEL POSITION |