Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CENTER AIRBAG SENSOR ASSEMBLY

CENTER AIRBAG SENSOR ASSEMBLY > REMOVAL

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)


3. REMOVE TRANSFER SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)


4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


  1. Detach the 12 claws and remove the upper console panel.

    NOTICE:
    Be careful not to damage the instrument panel and console box with the claws of the console panel.



    B277547E01


    Text in Illustration 
    *A
    for 2WD
    *B
    for 4WD



5. REMOVE CONSOLE BOX ASSEMBLY


B278048E01
  1. Remove the 4 screws and 2 bolts.

  1. Using a clip remover, remove the 2 clips and console box.
    Text in Illustration 
    *1
    Screw
    *2
    Bolt
    *3
    Clip



6. REMOVE CENTER AIRBAG SENSOR ASSEMBLY


H045596
  1. Disconnect the sensor connector.

  1. Remove the 3 bolts and sensor.