Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CENTER AIRBAG SENSOR ASSEMBLY

CENTER AIRBAG SENSOR ASSEMBLY > REMOVAL

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).



1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)


4. REMOVE TRANSFER SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)


5. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


  1. Detach the 12 claws and remove the upper console panel.

    NOTICE:
    Be careful not to damage the instrument panel and console box with the claws of the console panel.



    B277547E01


    Text in Illustration 
    *A
    for 2WD
    *B
    for 4WD



6. REMOVE CONSOLE BOX ASSEMBLY


B278048E01
  1. Remove the 4 screws and 2 bolts.

  1. Using a clip remover, remove the 2 clips and console box.
    Text in Illustration 
    *1
    Screw
    *2
    Bolt
    *3
    Clip



7. REMOVE CENTER AIRBAG SENSOR ASSEMBLY


H045596
  1. Disconnect the sensor connector.

  1. Remove the 3 bolts and sensor.