Home › BRAKE › BRAKE CONTROL › BRAKE ACTUATOR (w/ ABS)

BRAKE ACTUATOR (w/ ABS) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



3. REMOVE BRAKE ACTUATOR ASSEMBLY WITH BRACKET


    C121394E05
  1. Place tags or marks to identify the installation locations of each brake line.

    HINT:
    1. *1: to front wheel cylinder RH
    2. *2: to front wheel cylinder LH
    3. *3: to rear wheel cylinder
    4. *4: from master cylinder

  1. Release the latch of the actuator connector and disconnect the connector.



    C121395
  1. Using a union nut wrench, disconnect the 5 brake lines from the actuator.

  1. Remove the 3 bolts and actuator with bracket.

    NOTICE:
    Be careful not to damage the brake tubes.