BRAKE PEDAL (w/ VSC) > INSTALLATION |
| 1. INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY |
Install the support with the 4 nuts.
for Manual Transmission:
Attach the connector clamp and clamp to the brake pedal support sub-assembly.
Install the bolt to the support.
| 2. CONNECT BRAKE MASTER CYLINDER PUSH ROD CLEVIS |
Apply a light coat of lithium soap base glycol grease to the clevis pin.
Connect the push rod clevis to the brake pedal.
![]() |
Install the clevis pin and a new clip.
Install the return spring.
Connect the stop light switch connector and brake pedal load sensing switch connector.
| 3. CHECK AND ADJUST BRAKE PEDAL HEIGHT |
| 4. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY |
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |