Home › BRAKE › BRAKE › BRAKE PEDAL (w/ VSC)

BRAKE PEDAL (w/ VSC) > INSTALLATION

for Preparation Click here



1. INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY
  1. Install the support with the 4 nuts.

    Torque:
    14 N*m{ 145 kgf*cm , 10 ft.*lbf }

  1. for Manual Transmission:
    Attach the connector clamp and clamp to the brake pedal support sub-assembly.

  1. Install the bolt to the support.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



2. CONNECT BRAKE MASTER CYLINDER PUSH ROD CLEVIS
  1. Apply a light coat of lithium soap base glycol grease to the clevis pin.

  1. Connect the push rod clevis to the brake pedal.



    C226774E01
  1. Install the clevis pin and a new clip.

    NOTICE:
    The clip must be installed as shown in the illustration.

  1. Install the return spring.

  1. Connect the stop light switch connector and brake pedal load sensing switch connector.



3. CHECK AND ADJUST BRAKE PEDAL HEIGHT
(Click here)


4. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
(Click here)


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).