BRAKE PEDAL (w/ VSC) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY |
| 3. DISCONNECT BRAKE MASTER CYLINDER PUSH ROD CLEVIS |
Disconnect the stop light switch connector and brake pedal load sensing switch connector.
![]() |
Remove the return spring.
Remove the clip and clevis pin.
Disconnect the push rod clevis from the brake pedal.
| 4. REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY |
![]() |
for Manual Transmission:
Detach the connector clamp and clamp from the brake pedal support sub-assembly.
![]() |
Remove the bolt from the support.
![]() |
Remove the 4 nuts and support.