LOAD SENSING PROPORTIONING VALVE (w/ VSC) > ON-VEHICLE INSPECTION |
| 1. CHECK BLEND PROPORTIONING VALVE ASSEMBLY |
![]() |
Set the vehicle to its curb weight.
Place weights (as necessary) on the rear deck until the rear axle load is as shown below.
![]() |
Install SST, and bleed air from the brake system.
![]() |
Raise the front brake fluid pressure to 10000 kPa (107.6 kgf/cm2, 1450 psi) by depressing the brake pedal, and measure the rear brake fluid pressure.
| 2. CHECK VALVE BODY |
Check that the master cylinder rear brake fluid pressure changes according to the rear wheel cylinder pressure.
| Master Cylinder Pressure | Wheel Cylinder Pressure |
| 3430 kPa (35 kgf/cm2, 497 psi) | 2200 +/-200 kPa (22 +/-2 kgf/cm2, 319 +/-29 psi) |
| 7850 kPa (80 kgf/cm2, 1138 psi) | 6300 +/-390 kPa (64 +/-4 kgf/cm2, 913 +/-57 psi) |