Home › TRANSMISSION ยท A340E AUTOMATIC TRANSMISSION › TRANSMISSION WIRE

TRANSMISSION WIRE > REMOVAL

for Preparation Click here



1. DRAIN AUTOMATIC TRANSMISSION FLUID
  1. Remove the drain plug and gasket, and drain ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    20 N*m{ 205 kgf*cm , 15 ft.*lbf }



2. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY


G039346E01
  1. Remove the transmission oil level dipstick.

  1. Remove the 2 bolts and oil filler tube.

  1. Remove the O-ring from the oil filler tube.



3. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


C237771
  1. Remove the 19 bolts.



    Q007487E04
  1. Insert the blade of an oil pan cutter between the transmission case and oil pan. Cut through the seal and remove the oil pan.

    NOTICE:
    1. Be careful not to damage the oil pan flange.
    2. Some fluid will remain in the oil pan. Carefully remove the oil pan.

  1. Examine the particles in the oil pan.

    1. Remove all the magnets and use them to collect steel particles. Carefully look at the foreign matter and particles in the pan and on the magnets to determine the type of wear you will find in the transmission.
      Steel (magnetic): bearing, gear and clutch plate wear
      Brass (non-magnetic): bush wear



4. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


D028706E02
  1. Remove the 4 bolts and oil strainer.

    NOTICE:
    Be careful as some fluid may leak out of the oil strainer.

  1. Remove the 3 gaskets from the oil strainer.



5. REMOVE TRANSMISSION WIRE


G037235E01
  1. Disconnect the 4 connectors from the 4 shift solenoid valves.



    G036410E01
  1. Remove the bolt and stopper plate from the case.

  1. Pull out the transmission wire from the transmission case.

  1. Remove the O-ring from the transmission wire.