Home › TRANSMISSION ยท A343E AUTOMATIC TRANSMISSION › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > INSTALLATION

for Preparation Click here


HINT:
Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.



1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY


G034253E01
  1. Install the park/neutral position switch to the manual valve lever shaft.

  1. Temporarily install the bolt.

  1. Install a new lock washer and the nut.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



    D028682E01
  1. Turn the control shaft lever clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.

  1. Adjust the park/neutral position switch .

  1. Using a screwdriver, bend the tabs of the lock washer.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }

  1. Using a screwdriver, bend the tabs of the lock washer.



2. CONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



4. PERFORM INITIALIZATION
  1. Perform initialization (Click here).



5. ADJUST SHIFT LEVER POSITION
  1. Move the shift lever to N.



    G034515E02
  1. Remove the nut and disconnect the control cable.



    D028682E01
  1. Turn the control shaft lever clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.

  1. While holding the control shaft lever slightly toward the R position side, connect the cable with the nut.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }



6. INSPECT SHIFT LEVER POSITION
  1. When moving the shift lever from P to R with the ignition switch to ON and the brake pedal depressed, make sure that the shift lever moves smoothly and correctly into position.

  1. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D, and moves in reverse after shifting to R.
    If the results are not as specified, inspect the park/ neutral position switch and check the shift lever.



7. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Apply the parking brake and turn the ignition switch ON.

  1. Depress the brake pedal and check that the engine starts when the shift lever is on N or P, but does not start in other positions.

  1. Check that the back-up light illuminates and the reverse warning buzzer sounds when the shift lever is on R, but do not function in other positions.