PARK / NEUTRAL POSITION SWITCH > INSPECTION |
| 1. INSPECT PARK/NEUTRAL POSITION SWITCH |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 4 (B) - 5 (L) | Shift lever in P | Below 1 Ω |
| 2 (RB) - 1 (RL) | Shift lever in R | Below 1 Ω |
| 4 (B) - 5 (L) | Shift lever in N | Below 1 Ω |
| 2 (RB) - 7 (DL) | Shift lever in D or 3 | Below 1 Ω |
| 2 (RB) - 3 (2L) | Shift lever in 2 | Below 1 Ω |
| 2 (RB) - 8 (LL) | Shift lever in L | Below 1 Ω |
| 4 (B) - 5 (L) | Shift lever not in P | 10 kΩ or higher |
| 2 (RB) - 1 (RL) | Shift lever not in R | 10 kΩ or higher |
| 4 (B) - 5 (L) | Shift lever not in N | 10 kΩ or higher |
| 2 (RB) - 7 (DL) | Shift lever not in D or 3 | 10 kΩ or higher |
| 2 (RB) - 3 (2L) | Shift lever not in 2 | 10 kΩ or higher |
| 2 (RB) - 8 (LL) | Shift lever not in L | 10 kΩ or higher |
| *a | Component without harness connected (Park/Neutral Position Switch) |