Home › TRANSMISSION ยท A343F AUTOMATIC TRANSMISSION › ATF TEMPERATURE SENSOR

ATF TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL ATF TEMPERATURE SENSOR
  1. Coat a new O-ring with ATF and install it to the ATF temperature sensor.

  1. Using a 19 mm union nut wrench, Install the ATF temperature sensor.

    Torque:
    29 N*m{ 300 kgf*cm , 22 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque value for situations where a union nut wrench is combined with a torque wrench (Click here).

  1. Attach the ATF temperature sensor connector clamp to the wire harness bracket.

  1. Connect the ATF temperature sensor connector.



2. CHECK AUTOMATIC TRANSMISSION FLUID
(Click here)