AUTOMATIC TRANSMISSION ASSEMBLY > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE CONSOLE BOX ASSEMBLY |
| 4. REMOVE SHIFT LEVER BOOT ASSEMBLY |
![]() |
Remove the 4 screws and shift lever boot assembly.
| 5. REMOVE TRANSFER HIGH AND LOW SHIFT LEVER ASSEMBLY |
![]() |
Fold back the transfer front drive shift boot.
Using needle-nose pliers, remove the snap ring and pull out the shift lever.
| 6. REMOVE NO. 1 ENGINE UNDER COVER |
| 7. REMOVE NO. 2 ENGINE UNDER COVER |
| 8. REMOVE NO. 3 ENGINE UNDER COVER |
| 9. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
Remove the 2 bolts and 2 compression springs.
Disconnect the front pipe from the outlet pipe and remove the gasket.
Remove the front pipe from the pipe support.
| 10. REMOVE FRONT PROPELLER SHAFT ASSEMBLY |
| 11. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY |
| 12. DRAIN AUTOMATIC TRANSMISSION FLUID |
Remove the drain plug and gasket, and drain ATF.
Install a new gasket and the drain plug.
| 13. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY |
![]() |
Remove the oil level dipstick.
Remove the 2 bolts and transmission oil filler tube.
Remove the O-ring from the transmission oil filler tube.
| 14. REMOVE STARTER ASSEMBLY |
| 15. DISCONNECT OIL COOLER TUBE |
![]() |
Using a union nut wrench, disconnect the outlet oil cooler tube and inlet oil cooler tube.
![]() |
Remove the 3 bolts and 3 clamps.
| 16. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Remove the nut and clip, and disconnect the transmission control cable.
| 17. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY |
![]() |
Support the automatic transmission assembly with a transmission jack.
| 18. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY |
![]() |
Remove the 4 set bolts of the rear No. 1 engine mounting insulator.
Remove the 4 nuts, 4 bolts and No. 3 frame crossmember.
| 19. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR |
![]() |
Remove the 4 bolts and engine mounting insulator.
| 20. DISCONNECT WIRE HARNESS AND CONNECTOR |
![]() |
Remove the nut and disconnect the ground cable.
![]() |
Remove the 2 bolts and heat insulator.
![]() |
Tilt the transmission downward.
Disconnect the park/neutral position switch connector, transmission wire connector, 2 speed sensor connectors and transfer control side connector.

Disconnect the 8 wire harness clamps.
| 21. REMOVE DRIVE PLATE AND TORQUE CONVERTER SETTING BOLT |
Remove the flywheel housing dust seal.
Turn the crankshaft to gain access to each bolt.
![]() |
Hold the crankshaft pulley bolt with a wrench and remove the 6 torque converter setting bolts.
| 22. REMOVE MANIFOLD STAY |
![]() |
Remove the 3 bolts and manifold stay.
| 23. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY |
![]() |
Remove the 7 bolts and automatic transmission assembly.
| 24. REMOVE TRANSMISSION CONTROL CABLE BRACKET |
![]() |
Remove the 2 bolts and control cable bracket from the transmission.
| 25. REMOVE TRANSFER ASSEMBLY |
Remove the 8 bolts and 2 clamps.
Remove the transfer from the transmission.
| 26. REMOVE TORQUE CONVERTER ASSEMBLY |
Remove the torque converter from the automatic transmission assembly.