Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > DISPOSAL

for Preparation Click here



1. DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY
  1. Fully extend the shock absorber piston rod, and clamp it in a vise at an angle.



    C113162E01
  1. for 4WD, for Pre-Runner (except TMT and TASA Made):

    1. Using a drill or similar tool, gradually make a hole in area A to discharge the gas inside of the absorber.

      CAUTION:
      As metal debris may be blown outward by the gas, you must:
      1. Wear protective glasses.
      1. Cover the area being cut.

      NOTICE:
      The gas is colorless and harmless.



    C273331E02
  1. for Pre-Runner (TMT and TASA Made):

    1. Using a drill or similar tool, gradually make a hole in area A to discharge the gas inside of the absorber.

      CAUTION:
      As metal debris may be blown outward by the gas, you must:
      1. Wear protective glasses.
      1. Cover the area being cut.

      NOTICE:
      The gas is colorless and harmless.