Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL


2. DISCONNECT FRONT STABILIZER LINK ASSEMBLY LH


F049984E01
  1. Remove the nut and disconnect the stabilizer link from the steering knuckle.

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.



3. DISCONNECT FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



4. REMOVE FRONT STABILIZER BRACKET


C118728
  1. Remove the 4 bolts and 2 brackets.



5. REMOVE FRONT STABILIZER BAR
  1. Remove the stabilizer bar front from the vehicle body.



6. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING


    F049985E01
  1. for 4WD, for Pre-Runner (except TMT and TASA Made):

    1. Remove the nut and bolt.

      HINT:
      While fixing the nut in place, loosen and remove the bolt.



    C273330
  1. for Pre-Runner (TMT and TASA Made):

    1. Remove the nut and bolt.

      HINT:
      While fixing the nut in place, loosen and remove the bolt.



    F049986E01
  1. Remove the 3 nuts and shock absorber with coil spring.