Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > DISASSEMBLY

for Preparation Click here



1. REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT


F049987E01
  1. Secure SST in a vise.

    SST
    09727-30021   (09727-00010, 09727-00031)
    09727-00060  



    C275706E04
  1. Attach the arm of SST to the diameter of the coil spring.
    Text in Illustration 
    *a
    Correct
    *b
    Incorrect

    CAUTION:
    1. Make sure that the coil spring is installed so that the distance between the upper and lower hooks of SST is at the maximum.
    2. Make sure that the claws of the hooks are securely attached.

  1. Using SST, compress the coil spring.

    CAUTION:
    1. If the coil spring bends during the compression, immediately stop the compression and reinstall SST.
    2. Do not compress the spring until the coil springs contact each other.
    3. Do not use an impact wrench.



    F049988E01
  1. Hold the shock absorber rod and remove the nut.

    CAUTION:
    Do not remove the front support to front shock absorber nut when the coil spring is not free.



2. REMOVE FRONT SHOCK ABSORBER CUSHION RETAINER
  1. Remove the 2 cushion retainers from the shock absorber.



3. REMOVE FRONT SHOCK ABSORBER CUSHION
  1. Remove the cushion from the shock absorber.



4. REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY
  1. Remove the suspension support from the coil spring.



5. REMOVE FRONT COIL SPRING LH
  1. Remove the coil spring from the shock absorber.