Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT COIL SPRING LH


    C159782E02
  1. Secure SST in a vise.

    SST
    09727-30021   (09727-00010, 09727-00031)
    09727-00060  



    C275706E04
  1. Attach the arm of SST to the diameter of the coil spring.
    Text in Illustration 
    *a
    Correct
    *b
    Incorrect

    CAUTION:
    1. Make sure that the coil spring is installed so that the distance between the upper and lower hooks of SST is at the maximum.
    2. Make sure that the claws of the hooks are securely attached.

  1. Using SST, compress the coil spring.

    CAUTION:
    1. If the coil spring bends during the compression, immediately stop the compression and reinstall SST.
    2. Do not compress the spring until the coil springs contact each other.
    3. Do not use an impact wrench.



    F049992E02
  1. Install the coil spring to the shock absorber. Fit the lower end of the coil spring into the recess of the spring lower seat.
    Text in Illustration 
    *a
    Recess

  1. Install the insulator, 2 retainers, cushion and front suspension support to the rod.

  1. Temporarily install a new lock nut.



2. INSTALL FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT


C113160E01
  1. Align the suspension support and absorber bush as shown in the illustration.

  1. Tighten the lock nut.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    NOTICE:
    Do not use an impact wrench. It will damage the shock absorber rod.

  1. Release the coil spring while checking the position of the spring lower seat and suspension support.