Home › SUSPENSION & AXLE › SUSPENSION › FRONT UPPER SUSPENSION ARM

FRONT UPPER SUSPENSION ARM > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL


2. INSPECT FRONT SUSPENSION UPPER ARM ASSEMBLY
  1. Check that there is no looseness on the ball joint by shaking the upper arm up and down by hand.



3. DISCONNECT SKID CONTROL SENSOR WIRE


F049997E01
  1. Remove the 2 bolts and disconnect the skid control sensor wire.



4. REMOVE FRONT SUSPENSION UPPER ARM ASSEMBLY LH


F049998E01
  1. Support the lower arm with a jack.

  1. Remove the clip and nut.

  1. Using SST, disconnect the upper ball joint from the steering knuckle.

    SST
    09628-62011  



    F050000E01
  1. Remove the nut, 2 retainers and bolt.

  1. Remove the upper arm.