Home › DRIVE LINE › PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY (for TDV Made)

FRONT PROPELLER SHAFT ASSEMBLY (for TDV Made) > REMOVAL

for Preparation Click here



1. REMOVE FRONT PROPELLER SHAFT ASSEMBLY


C098708E01
  1. Place matchmarks on the propeller shaft flange and differential.

  1. Remove the 4 nuts, 4 bolts and 4 washers, and disconnect the propeller shaft.



    F052086E01
  1. Place matchmarks on the propeller shaft flange and transfer flange.

  1. Remove the 4 nuts, 4 washers and front propeller shaft.



2. INSPECT FRONT PROPELLER SHAFT ASSEMBLY


F052087E01
  1. Using a dial indicator, measure the propeller shaft runout.

    Maximum runout:
    0.80 mm (0.0315 in.)

    If the runout is greater than the maximum, replace the propeller shaft.



3. INSPECT UNIVERSAL JOINT SPIDER ASSEMBLY
  1. Check the spider bearings for wear or damage.

  1. Check each spider bearing's axial play by turning the yoke while holding the shaft tightly.

    Maximum bearing axial play:
    0.05 mm (0.0020 in.)

    If the axial play is greater than the maximum, replace the spider bearing.