POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function) > TERMINALS OF ECU |
| CHECK POWER WINDOW REGULATOR MASTER SWITCH |

Disconnect the P6 switch connector.
Measure the voltage and resistance of the wire harness side connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| B (P6-6) - Body ground | L - Body ground | Ignition power supply | Ignition switch OFF | Below 1 V |
| B (P6-6) - Body ground | L - Body ground | Ignition power supply | Ignition switch ON | 10 to 14 V |
| BW (P6-7) - Body ground | L-B - Body ground | Regulator motor power supply | Always | 10 to 14 V |
| E (P6-1) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the P6 switch connector.
Reset the power window motor (Click here).
Measure the voltage of the connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| U (P6-4) - E (P6-1) | R - W-B | Driver side power window motor UP output | Ignition switch ON, driver side power window switch OFF → UP (manual operation) | Below 1 V → 10 to 14 V |
| Ignition switch ON, driver side power window fully open → driver side power window switch UP (AUTO operation) → driver side power window fully closed | Below 1 V → 10 to 14 V → Below 1 V | |||
| D (P6-9) - E (P6-1) | L-R - W-B | Driver side power window motor DOWN output | Ignition switch ON, driver side power window switch OFF → DOWN (manual operation) | Below 1 V → 10 to 14 V |
| Ignition switch ON, driver side power window fully closed → driver side power window switch DOWN (AUTO operation) → driver side power window fully open | Below 1 V → 10 to 14 V → Below 1 V | |||
| U (P6-13) - E (P6-1) | R-L - W-B | Front passenger side power window motor UP output |
| Below 1 V → 10 to 14 V |
| D (P6-15) - E (P6-1) | G-W - W-B | Front passenger side power window motor DOWN output |
| Below 1 V → 10 to 14 V |
| U (P6-12) - E (P6-1) | R-Y - W-B | Rear power window LH motor UP output |
| Below 1 V → 10 to 14 V |
| D (P6-10) - E (P6-1) | G-Y - W-B | Rear power window LH motor DOWN output |
| Below 1 V → 10 to 14 V |
| U (P6-18) - E (P6-1) | R-B - W-B | Rear power window RH motor UP output |
| Below 1 V → 10 to 14 V |
| D (P6-16) - E (P6-1) | G-B - W-B | Rear power window RH motor DOWN output |
| Below 1 V → 10 to 14 V |
| VCC (P6-3) - GND (P6-2) | BR - L-O | Power window motor sensor power source | Ignition switch ON, driver side power window switch OFF → UP or DOWN | Below 1 V → 10 to 14 V |
Check the AUTO light illumination.
After turning the ignition switch ON, check that the AUTO light illuminates (green).