POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function) > ON-VEHICLE INSPECTION |
| 1. CHECK POWER WINDOW REGULATOR MASTER SWITCH (WINDOW LOCK SWITCH) |
![]() |
Check that operations of the front passenger side power window and rear power windows are disabled when the window lock switch of the power window regulator master switch is pressed.
Check that the front passenger side power window and rear windows can be operated when the window lock switch is pressed again.
| 2. CHECK MANUAL UP / DOWN FUNCTION |
Check that the driver side power window operates as follows:
| Condition | Master Switch | Switch Operation | Power Window |
| Ignition switch ON | Driver side | Pulled halfway up | UP (closes) |
| Ignition switch ON | Driver side | Pushed halfway down | DOWN (opens) |
Check that the front passenger side power window operates as follows:
| Condition | Regulator Switch | Switch Operation | Power Window |
| Front passenger side | Pulled up | UP (closes) |
| Front passenger side | Pushed down | DOWN (opens) |
Check that the rear power window LH operates as follows:
| Condition | Regulator Switch | Switch Operation | Power Window |
| Rear LH | Pulled up | UP (closes) |
| Rear LH | Pushed down | DOWN (opens) |
Check that the rear power window RH operates as follows:
| Condition | Regulator Switch | Switch Operation | Power Window |
| Rear RH | Pulled up | UP (closes) |
| Rear RH | Pushed down | DOWN (opens) |
| 3. CHECK AUTO UP / DOWN FUNCTION |
Check that the driver side power window operates as follows:
| Condition | Master Switch | Switch Operation | Power Window |
| Ignition switch ON | Driver side | Fully pushed down | AUTO DOWN (fully opens) |
| Ignition switch ON | Driver side | Fully pulled up | AUTO UP (fully closes) |
| 4. CHECK REMOTE UP / DOWN FUNCTION |
Check that the front passenger side power window operates as follows:
| Condition | Master Switch | Switch Operation | Power Window |
| Front passenger side | Pulled up | UP (closes) |
| Front passenger side | Pushed down | DOWN (opens) |
Check that the rear power window LH operates as follows:
| Condition | Master Switch | Switch Operation | Power Window |
| Rear LH | Pulled up | UP (closes) |
| Rear LH | Pushed down | DOWN (opens) |
Check that the rear power window RH operates as follows:
| Condition | Master Switch | Switch Operation | Power Window |
| Rear RH | Pulled up | UP (closes) |
| Rear RH | Pushed down | DOWN (opens) |
| 5. CHECK PTC OPERATION |
Disconnect the driver side power window regulator motor.
Connect the ammeter's positive (+) lead to terminal 2 of the wire harness side connector and the negative (-) lead to battery's negative terminal.
Connect the battery's positive (+) lead to terminal 1 of the wire harness side connector, and raise that window to the fully closed position.
Continue to apply voltage, and check that the current changes to less than 1A within 4 to 90 seconds.
Disconnect the leads from the terminals.
Approximately 60 seconds later, connect the battery's positive (+) lead to terminal 2 and the negative (-) lead to terminal 1, and check that the window begins to lower.
| 6. CHECK JAM PROTECTION FUNCTION (for Driver Side) |
![]() |
Check that the door glass lowers by approximately 50 mm (1.97 in.) when something is caught between the door frame and door glass during power window operation. However, when the opening between the door frame and the door glass is less than 200 mm (7.87 in.), the door glass continues to lower and does not stop until an opening of 200 mm (7.87 in.) is achieved.
| 7. CHECK POWER WINDOW FAIL-SAFE FUNCTION (for Driver Side) |