POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function) > Remote Up / Down Function does not Operate |

| 1.CHECK POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY |
![]() |
Turn the window lock switch OFF and operate the switches on the master switch. Check that the remote UP / DOWN function operates normally.
|
| ||||
| OK | ||
| ||
| 2.CHECK MANUAL UP / DOWN FUNCTION |
Check that the front passenger door power window and rear door power window manual UP / DOWN function operates normally.
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (MASTER SWITCH - FRONT PASSENGER SIDE SWITCH) |

Disconnect the P6 master switch connector.
Disconnect the P11 switch connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| P6-13 (U) - P11-1 | Below 1 Ω |
| P6-15 (D) - P11-4 | Below 1 Ω |
| P6-13 (U) or P11-1 Body ground | 10 kΩ or higher |
| P6-15 (D) or P11-4 Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK WIRE HARNESS (MASTER SWITCH - REAR SWITCH LH) |

Disconnect the P6 master switch connector.
Disconnect the P12 switch connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| P6-12 (U) - P12-1 | Below 1 Ω |
| P6-10 (D) - P12-4 | Below 1 Ω |
| P6-12 (U) or P12-1 Body ground | 10 kΩ or higher |
| P6-10 (D) or P12-4 Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK WIRE HARNESS (MASTER SWITCH - REAR SWITCH RH) |

Disconnect the P6 master switch connector.
Disconnect the P13 switch connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| P6-18 (U) - P13-1 | Below 1 Ω |
| P6-16 (D) - P13-4 | Below 1 Ω |
| P6-18 (U) or P13-1 Body ground | 10 kΩ or higher |
| P6-16 (D) or P13-4 Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||