SIDE TURN SIGNAL LIGHT ASSEMBLY > INSTALLATION |
| 1. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH |
Connect the connector.
Install the side turn signal light assembly LH with the 2 screws.
| 2. INSTALL OUTER MIRROR COVER LH |
Attach the 2 claws as shown in the illustration.

Attach the 6 claws to install the outer mirror cover LH.
![]() |
After installing the outer mirror cover, check that there is no gap between the cover and mirror body.
If there is a gap between the cover and body, noise will occur during driving.
![]() |
Using a T25 "TORX" socket wrench, install the screw.
| *1 | Adhesive |
![]() |
Using a T25 "TORX" socket wrench, install the screws.
| *1 | Adhesive |
Attach the 5 claws.
Install the rubber base with the screw.
![]() |
Apply new tape as shown in the illustration.
| *1 | Tape |
| *a | 40 mm (1.58 in.) |
| 3. INSTALL OUTER MIRROR LH |
![]() |
Attach the 2 claws as shown in the illustration.
![]() |
Attach the 2 clips to install the outer mirror LH.
| 4. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH |