Home › BODY ELECTRICAL › LIGHTING › ROOM LIGHT ASSEMBLY

ROOM LIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE NO. 1 ROOM LIGHT ASSEMBLY


    E225173
  1. Using a screwdriver wrapped with protective tape, detach the 4 claws and remove the lens.

    HINT:
    Protective tape the screwdriver tip before use.



    B117645
  1. Remove the 2 screws and room light.

  1. Disconnect the light connector.



3. REMOVE NO. 1 ROOM LIGHT BULB
  1. Remove the bulb from the room light.



4. REMOVE NO. 2 ROOM LIGHT ASSEMBLY


    E225173
  1. Using a screwdriver wrapped with protective tape, detach the 4 claws and remove the lens.

    HINT:
    Protective tape the screwdriver tip before use.



    B117645
  1. Remove the 2 screws and room light.

  1. Disconnect the light connector.



5. REMOVE NO. 2 ROOM LIGHT BULB
  1. Remove the bulb from the room light.