Home › BODY ELECTRICAL › WIPER AND WASHER › FRONT WIPER MOTOR

FRONT WIPER MOTOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT WIPER ARM HEAD CAP


    E225502
  1. Using a screwdriver, remove the front wiper arm head cap.

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure for both front wiper arm head caps.



4. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH


    E225271
  1. Remove the nut and the front wiper arm and blade assembly LH.



5. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH


    E225272
  1. Remove the nut and the front wiper arm and blade assembly RH.



6. REMOVE HOOD TO COWL TOP SEAL


    E225273
  1. Using a clip remover, detach the 9 clips and remove the hood to cowl top seal.



7. REMOVE COWL TOP VENTILATOR LOUVER RH


    E225275
  1. Remove the clip.

  1. Detach the 5 claws and 5 guides, and remove the cowl top ventilator louver RH in the direction indicated by the arrow in the illustration.



8. REMOVE COWL TOP VENTILATOR LOUVER LH


    E225274
  1. Remove the clip.

  1. Detach the 5 guides, and remove the cowl top ventilator louver LH in the direction indicated by the arrow in the illustration.



9. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY


E225276
  1. Disconnect the connector.

  1. Remove the 2 bolts.

  1. Move the wiper cushion in the direction shown by the arrow in the illustration to detach the wiper cushion from the body, and remove the wiper motor and link.



10. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY


    E225277
  1. Using a screwdriver, disconnect the 2 rods of the wiper link from the wiper motor as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.



    E225278
  1. Using a T30 "TORX" socket, remove the 2 bolts and wiper motor.