WASHER MOTOR > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE WASHER INLET SUB-ASSEMBLY |
![]() |
Remove the clip.
Pull the washer inlet of the washer jar and pump upward. Then remove it from the windshield washer jar and pump.
| 4. REMOVE RADIATOR GRILLE |
![]() |
Remove the 2 clips and 2 screws.
![]() |
Put protective tape around the radiator grille.
| *1 | Protective Tape |
Detach the 6 claws and remove the radiator grille.
| 5. REMOVE FRONT BUMPER HOLE COVER LH (w/o Fog Light) |
![]() |
Put protective tape around the front bumper hole cover.
Using the screwdriver, detach the 8 claws and remove the front bumper hole cover.
| *1 | Protective Tape |
| 6. REMOVE FRONT BUMPER HOLE COVER RH (w/o Fog Light) |
| 7. REMOVE FOG LIGHT COVER LH (w/ Fog Light) |
![]() |
Put protective tape around the fog light cover.
Using the screwdriver, detach the 8 claws and remove the fog light cover.
| *1 | Protective Tape |
| 8. REMOVE FOG LIGHT COVER RH (w/ Fog Light) |
| 9. REMOVE FRONT BUMPER COVER |
![]() |
Remove the 6 screws and 3 clips.
![]() |
Put protective tape around the front bumper cover.
Remove the 2 screws, 2 bolts and 5 clips.
| *1 | Protective Tape |
![]() |
Detach the 8 claws and remove the front bumper cover.
w/ Headlight Cleaner System:
Disconnect the headlight cleaner hose, and then drain the washer fluid.
w/ Fog Light:
Disconnect the 2 fog light connectors.
| 10. DRAIN WASHER FLUID |
![]() |
Disconnect the washer hose from the windshield washer motor and pump, and drain the washer fluid.
| 11. REMOVE WINDSHIELD WASHER JAR ASSEMBLY |
![]() |
Remove the grommet.
![]() |
Disconnect the 2 connectors and 2 washer hoses.
Detach the 3 clamps and remove the 3 bolts. Then remove the washer jar and pump.
| 12. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY |
![]() |
Pull out the washer motor and pump from the packing of the washer jar.
| 13. REMOVE REAR WASHER MOTOR AND PUMP ASSEMBLY |
![]() |
Pull out the rear washer motor and pump from the packing of the washer jar.