METER / GAUGE SYSTEM > Entire Combination Meter does not Operate |

| 1.INSPECT FUSE (DCC, DOME, MET) |
Remove the DCC and DOME fuses from the engine room junction block.
Remove the MET fuse from the driver side junction block.
Measure the resistance of the fuses.
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (METER - BATTERY AND BODY GROUND) |
![]() |
Disconnect the C26 meter connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| C26-1 - Body ground | Always | 11 to 14 V |
| C26-21 - Body ground | Ignition switch ON | 11 to 14 V |
| C26-21 - Body ground | Ignition switch OFF | Below 1 V |
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| C26-22 - Body ground | Below 1 Ω |
|
| ||||
| OK | ||
| ||