METER / GAUGE SYSTEM > Tachometer Malfunction |

| 1.CHECK COMBINATION METER ASSEMBLY |
![]() |
Disconnect the C26 meter connector.
Using an oscilloscope, check the signal waveform of the meter.
| Tester Connection | Tool Setting | Vehicle Condition |
| C26-7 - Body ground | 5 V/DIV., 10 msec./DIV. | Engine idling |
|
| ||||
| NG | |
| 2.CHECK WIRE HARNESS (METER - ECM) |
Disconnect the C26 meter connector.
Disconnect the E13*1, E9*2, E4*3 or E25*4 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| C26-7 - E13-1 (TACH) | Below 1 Ω |
| C26-7 - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| C26-7 - E9-1 (TACH) | Below 1 Ω |
| C26-7 - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| C26-7 - E4-4 (TACH) | Below 1 Ω |
| C26-7 - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| C26-7 - E25-29 (TACH) | Below 1 Ω |
| C26-7 - Body ground | 10 kΩ or higher |
| Result | Proceed to |
| OK (1GR-FE, 2TR-FE, 2TR-FE) | A |
| OK (1KD-FTV,) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||