Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Tachometer Malfunction

for Preparation Click here


WIRING DIAGRAM


E252854E05


E253437E01


INSPECTION PROCEDURE

1.CHECK COMBINATION METER ASSEMBLY
E234304E03
  1. Disconnect the C26 meter connector.

  1. Using an oscilloscope, check the signal waveform of the meter.
    Tester Connection
    Tool Setting
    Vehicle Condition
    C26-7 - Body ground
    5 V/DIV., 10 msec./DIV.
    Engine idling

    OK:
    Refer to the illustration.

    HINT:
    As the engine speed increases, the wavelength shortens.



OK
REPLACE COMBINATION METER ASSEMBLY
NG


2.CHECK WIRE HARNESS (METER - ECM)
  1. Disconnect the C26 meter connector.

  1. Disconnect the E13*1, E9*2, E4*3, E32*4 or E25*5 ECM connector.

    1. *1: for 1GR-FE
    2. *2: for 2TR-FE
    3. *3: for 1KD-FTV (w/ EGR Cooler)
    4. *4: for 1KD-FTV (w/ i-ART)
    5. *5: for 2TR-FBE

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for 1GR-FE 
    Tester Connection
    Specified Condition
    C26-7 - E13-1 (TACH)
    Below 1 Ω
    C26-7 - Body ground
    10 kΩ or higher

    for 2TR-FE:
    Tester Connection
    Specified Condition
    C26-7 - E9-1 (TACH)
    Below 1 Ω
    C26-7 - Body ground
    10 kΩ or higher

    for 1KD-FTV (w/ EGR Cooler):
    Tester Connection
    Specified Condition
    C26-7 - E4-4 (TACH)
    Below 1 Ω
    C26-7 - Body ground
    10 kΩ or higher

    for 1KD-FTV (w/ i-ART):
    Tester Connection
    Specified Condition
    C26-7 - E32-18 (TACH)
    Below 1 Ω
    C26-7 - Body ground
    10 kΩ or higher

    for 2TR-FBE:
    Tester Connection
    Specified Condition
    C26-7 - E25-29 (TACH)
    Below 1 Ω
    C26-7 - Body ground
    10 kΩ or higher

    Result  
    Result
    Proceed to
    OK (1GR-FE, 2TR-FE, 2TR-FE)
    A
    OK (1KD-FTV,)
    B
    NG
    C



B
GO TO ECD SYSTEM

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

GO TO SFI SYSTEM