METER / GAUGE SYSTEM > Engine Coolant Temperature Gauge Malfunction |

| 1.CHECK FOR DTC |
Check for DTCs of the SFI system (1GR-FE, 2TR-FE, 2TR-FBE) or ECD system (1KD-FTV).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output (1GR-FE, 2TR-FE, 2TR-FBE) | B |
| DTC is output (1KD-FTV) | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK WIRE HARNESS (METER - ECM) |
Disconnect the C26 meter connector.
Disconnect the E13*1, E9*2, E4*3 or E22*4 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| C26-4 - E13-14 (THWO) | Below 1 Ω |
| C26-4 - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| C26-4 - E9-14 (THWO) | Below 1 Ω |
| C26-4 - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| C26-4 - E4-2 (THWO) | Below 1 Ω |
| C26-4 - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| C26-4 - E22-26 (THWO) | Below 1 Ω |
| C26-4 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||