Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > INITIALIZATION

for Preparation Click here


HINT:
The procedures described below are for vehicles with a 1KD-FTV or 2KD-FTV engine.


DESCRIPTION
  1. T-BELT warning light

    1. The T-BELT warning light turns on when the odometer displays 150,000 km to indicate that the timing belt should be replaced.

  2. Fuel system warning light

    1. The fuel system warning light illuminates when a fuel filter clog is detected.

    2. The fuel system warning light blinks when a certain amount of water is accumulated at the bottom of the fuel filter.


RESET T-BELT WARNING LIGHT

NOTICE:
  1. When the T-BELT indicator light is illuminated, replace the timing belt and perform this procedure.
  2. After the timing belt is replaced, perform this procedure so that the T-BELT indicator light does not turn on.

HINT:
The timing belt maintenance system turns on the T-BELT indicator light to inform the driver that it is time to replace the timing belt based on the distance driven.

  1. Turn the ignition switch to ON, and use the ODO/ TRIP switch to change the screen display to TRIP B.

  2. Turn the ignition switch to off.

  3. While holding in the ODO/TRIP switch, turn the ignition switch to ON and check that the T-BELT indicator light blinks.

  4. Press and hold the ODO/TRIP switch for 5 seconds or more.

    HINT:
    If the ODO/TRIP switch is released (off is detected) within 5 seconds, the ODO/TRIP display, indicator display, and the integrated value will return to the state before the reset operation began.

  5. After the ODO/TRIP switch is turned off, turn the ODO/TRIP switch on again within 5 seconds.

  6. After the ODO/TRIP switch is turned on, enter the setting mode and change to T-BELT display mode.



  7. Change the set value in increments by turning the ODO/TRIP switch (the value must be changed within 5 seconds). (procedure A)


    E157121E03

    HINT:
    Perform this procedure only when changing the previously set value.

    NOTICE:
    If the ODO/TRIP switch is not turned from on to off for 30 seconds or more during this step, the previously set value will be maintained and the TRIP B display will return (reset will not complete).

  8. When the display changes to the desired setting, press the ODO/TRIP switch for 5 seconds or more to finish setting mode. (procedure B)

  9. The ODO display area changes to the TRIP B display, the warning indicator turns off simultaneously and reset mode is completed. (procedure C)

    NOTICE:
    When not changing the previously set value, do not perform the operations in procedure A above, only perform procedures B and C.


RESET FUEL SYSTEM WARNING LIGHT
  1. When the fuel system warning light blinks, drain accumulated water from the fuel filter assembly.

  2. When the fuel system warning light illuminates, follow the procedures below to reset the combination meter.

    1. Replace the fuel filter.

    2. Disconnect the F9 filter warning switch connector.

    3. Turn the ignition switch ON.

    4. Wait 3 seconds.

    5. Reconnect the F9 connector within 57 seconds.

    6. Make sure that the fuel system warning light turns off 3 seconds after the connector is reconnected.