Home › ENGINE ยท 1GR-FE › EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here


CAUTION:
  1. Wear protective gloves when removing the exhaust pipe.
  2. The exhaust pipe is extremely hot immediately after the engine has stopped.
  3. Confirm that the exhaust pipe has cooled down before removing it.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


A112020E03
  1. Disconnect the sensor connector.

  1. Using SST, remove the sensor from the front exhaust pipe.

    SST
    09224-00010  



4. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


A112022E03
  1. Disconnect the sensor connector.

  1. Using SST, remove the sensor from the front exhaust pipe.

    SST
    09224-00010  



5. REMOVE TAILPIPE ASSEMBLY
  1. Remove the 2 bolts, exhaust pipe support and tailpipe.



6. REMOVE CENTER EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolts and 2 compression springs.

  1. Remove the 3 exhaust pipe supports and exhaust pipe.



7. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolts, 2 nuts, pipe support and exhaust pipe.



8. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Remove the 2 nuts, pipe support and exhaust pipe.