Home › TRANSMISSION ยท CLUTCH › CLUTCH RELEASE CYLINDER (for 1GR-FE)

CLUTCH RELEASE CYLINDER (for 1GR-FE) > INSTALLATION

for Preparation Click here



1. INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY


C112662
  1. Install the clutch release cylinder with the 2 bolts.

    Torque:
    12 N*m{ 120 kgf*cm , 9 ft.*lbf }



2. CONNECT CLUTCH RELEASE CYLINDER TO ACCUMULATOR TUBE


    C112616
  1. Using a union nut wrench, connect the flexible tube.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque value for situations where a union nut wrench is combined with a torque wrench (Click here).

  1. Install the 2 way with the bolt.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }



3. CONNECT CLUTCH RELEASE CYLINDER FLEXIBLE TUBE


    C112615
  1. Using SST, install the flexible tube.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque value for situations where a union nut wrench is combined with a torque wrench (Click here).



4. INSTALL RELEASE CYLINDER HEAT INSULATOR


C112617
  1. Install the insulator with the bolt and nut.

    Torque:
    12 N*m{ 120 kgf*cm , 9 ft.*lbf }



5. BLEED AIR FROM CLUTCH PIPE LINE
(Click here)


6. CHECK FLUID LEVEL IN RESERVOIR
w/VSC:
w/o VSC:


7. CHECK FOR CLUTCH FLUID LEAKAGE