Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for Manual Seat)

FRONT SEAT INNER BELT ASSEMBLY (for Manual Seat) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT SEAT ASSEMBLY
  1. Remove the front seat assembly (Click here).



4. REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)


B284015
  1. Detach the clamp.



    B278432
  1. Detach the wire harness from the clamp.

  1. Roll up the front seat cushion cover LH.

  1. Remove the nut and front seat inner belt assembly LH.



5. REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)


B113100E01
  1. w/ Passenger seat belt warning light:
    Detach the 2 clamps.

  1. w/ Passenger seat belt warning light:
    Disconnect the connector.



    B278431
  1. w/ Passenger seat belt warning light:
    Detach the wire harness from the clamp.

  1. Roll up the front seat cushion cover RH.

  1. Remove the nut and front seat inner belt assembly RH.



6. REMOVE FRONT SEAT CUSHION COVER LH


    B284016E01
  1. Remove the front seat cushion cover LH.

    HINT:
    Use the same procedure to remove the front seat cushion cover on the other side.