Home › ENGINE · 2TR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM (w/o Secondary Air Injection System)

SFI SYSTEM (w/o Secondary Air Injection System) > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

Terminals TC and CG are located in the DLC3. When connecting these terminals, DTCs in normal mode or check mode can be determined through MIL flashing patterns in the combination meter.

WIRING DIAGRAM


A120231E01


INSPECTION PROCEDURE

HINT:
If either of the following symptoms is present, it is determined that an open or a short in the wire harness has occurred, or there has been a malfunction in the ECM.
  1. The MIL displaying function does not work even though terminals TC and CG of the DLC3 are connected.
  2. The MIL flashes even though terminals TC and CG of the DLC3 are not connected.

1.CHECK DLC3 (TC VOLTAGE)
A120003E01
  1. Turn the ignition switch ON.

  1. Measure the voltage of the DLC3.

    Standard voltage:
    Tester Connection
    Specified Condition
    D3-13 (TC) - D3-4 (CG)
    9 to 14 V



OK
Go to step 3
NG


2.CHECK WIRE HARNESS (DLC3 - ECM)
G034707E02
  1. Disconnect the E9 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    D3-13 (TC) - E9-17 (TC)
    Below 1 Ω
    D3-13 (TC) or E9-17 (TC) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPAIR OR REPLACE HARNESS AND CONNECTOR (DLC3 - BODY GROUND) 

3.CHECK IF MIL BLINKS
A120003E02
  1. Turn the ignition switch ON.

  1. Using SST, connect terminals TC and CG of the D3 DLC3 connector.

  1. Check that the MIL blinks.

    OK:
    The MIL blinks.

SST
09843-18040  


NG
REPLACE ECM
OK

NO PROBLEM