REAR CRANKSHAFT OIL SEAL > INSTALLATION |
| 1. INSTALL REAR CRANKSHAFT OIL SEAL |
Apply MP grease to the lip of a new rear crankshaft oil seal.
![]() |
Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
| 2. INSTALL PUMP IMPELLER DRIVE PLATE (for Automatic Transmission) |
Clean the bolts and their holes.
![]() |
Using SST, hold the crankshaft pulley.
![]() |
Install the flywheel and ring gear, the pump impeller drive plate and the rear drive plate spacer to the crankshaft.
| *1 | Flywheel and Ring Gear |
| *2 | Pump Impeller Drive Plate |
| *3 | Rear Drive Plate Spacer |
| *a | Engine Side |
| *b | Transmission Side |
![]() |
Install and uniformly tighten and tighten the 8 bolts in several steps in the sequence shown in the illustration.
| 3. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transmission) |
Clean the bolts and their holes.
Apply adhesive to 2 or 3 threads at the end of each bolt.
![]() |
Using SST, hold the crankshaft pulley.
Install the flywheel to the crankshaft.
![]() |
Install and uniformly tighten and tighten the 8 bolts in the sequence shown in the illustration.
| 4. INSTALL CLUTCH DISC ASSEMBLY (for Manual Transmission) |
![]() |
Insert SST into the clutch disc. Then insert SST (together with the clutch disc) into the flywheel.
| 5. INSTALL CLUTCH COVER ASSEMBLY (for Manual Transmission) |
![]() |
Align the matchmarks on the clutch cover and flywheel.
Tighten the 6 bolts as described below.
Determine the first bolt to be tightened by choosing the bolt closest to the knock pin.
Uniformly tighten the 6 bolts in diametrically opposite pairs relative to the position of the first bolt. Use the illustration as a reference.
Lightly move SST up and down, and right and left.
Check that the disc is in the center, and then tighten the bolts.
| 6. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY (for Manual Transmission) |
![]() |
Using a dial indicator with roller instrument, measure the diaphragm spring tip alignment.
![]() |
| 7. INSTALL AUTOMATIC TRANSMISSION (for Automatic Transmission) |
| 8. INSTALL MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission) |