AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > Radio Receiver Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - BATTERY AND BODY GROUND) |
![]() |
Disconnect the R20 and R21 radio and display receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R20-7 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R20-4 (B) - Body ground | Always | 11 to 14 V |
| R20-3 (ACC) - Body ground | Ignition switch ACC | |
| R21-1 (IG) - Body ground | Ignition switch ACC |
| *a | Front view of wire harness connector (to Radio and Display Receiver Assembly) |
|
| ||||
| OK | ||
| ||